Rapid switching may result in a malfunction. You can use your fax to both poll and by others. Pick up the handset and check for a dial tone. If the monitor is connected to a computer, turn on the monitor first before turning on the computer. You can also have the fax automatically print out a repoti on transactions after they are made. You should never perform any of this work yourself. This will prevent stray or disorganized cables at the back of the monitor.
Press to increase the volume, and to decrease the volume. Up to 11 minutes of voice messages can be recorded when no documents are stored in memory this may vary depending on the content of the messages. The performance specification figures Indicated are nominal values of production units. Also, the cables connected to the terminals on the back of the monitor from the external equipment can be neatly bundled using the supplied cable clamps as shown in the illustration below. Press or to adjust the setting. Please note that these stands are for temporary use only until the monitor is properly mounted.
When the connection is made, trans- mission begins. If you have any difficulty refer to the detailed instructions on the page shown below the setting. Installation 8 Close the operation panel,. If no messages have been received In the box, you wil! The ends of the handset lead are iden- ttcal. It can be used for both fax transmis- sions and voice calls.
Installation Connecting the Handset Connect the handset as shown. Ya intenté con la tecla funcion, luego 0 luego y luego grabe un mensaje en la caja-1 , caja-2 , caja-3 y en el general, pero no se activa. Replace the handset if you used it. Check the display for error messages. If you are on a pulse dial phone. My Life On The Plains With Illustrations File Name: My Life On The Plains With Illustrations.
When polling is finished, the document will be automat- ically transmitted. Installation Setting the Reception Mode Your. This Ilst shows information about the messages currently recorded In the answenng machine. Your fax has 4 resolution settings. If this is done, the passcode must be entered before messages in the box can be listened to or erased. Our company will bear no responsibility for accidents or injuries caused by improper mounting or handling.
Less can be held if To see in the feeder. If the temperature inside the monitor rises, this could lead to a malfunction. If desired, you can change this setting to 15, 30, or 60 seconds. Adjustable range 0 - 255 Default 127 + direction Clock frequency increases. Instructions for making each setting appear in the display. Use it for the followlng types of documents Documents wnlc~ are torn Documents smaller than the mlnlmum size Carbon-backed documents Insert a sheet of white paper between the carbon back of the document and the document carrier. Hola, tengo un fax sharp f0-475 y no puedo cambiarle el mensaje del contestador.
The bottom part of the list shows the status of the settings made for answering machine connection. Answering Machine Connection Connecting an Answering Machine If desired, you. The document will be automatically transmitted once the connection ts made. ~hlsrunctlon Canbe usea to make sample copies of documents to De transmitted to see :f the resolution or contrast needs adjustment. Printing Lists Telephone Number List This list shows. We are not at home right now, If you would like to leave a general message, please speak after the beep.
The other machine is then dlalled redlalllng will be per- formed automatically if necessary. Press the appropriate Rapid Key. The answering machine is set at the factory to allow each caller a maximum of 4 minutes to leave a message. Up to 2 redialling attemp~swill be made at intewals of 5 minutes. This allows you to save money on telephone charges, particularly if you are calling long distance. When using the adjustment pattern see page 36 , make adjustments so that no vertical stripe noise appears in it.
Press the keys shown at left. One transmission operation and one polling operation can be set at any one time, and the times they will be performed can be specified up to 24 hours in advance. Press to increase the brightness of the screen, and to decrease the brightness of the screen. Specific guidelines are as follows: The size and weight of documents which you can load in the document feeder depend on whether you load one sheet at a time or several sheets at once. You can also use these commands to change the reception mode and other settings. Installation 3 If you are loading.