I was going to send it away to have it fixed. Even though myself i used to work in a repair centre, every laptop is different. Switch air direction a few times until the cooling module is clean. I tried three different chargers with all the same result. Does it spin at all? Turns out there was a whole load of dust in there and I think it was overheating. Lastly there is a bit of technique to applying thermal paste that can make a big difference. I opened it again just to make sure I put everything back in place and everything seemed to be okay.
I use Win7… so maybe you can help? Remove the motherboard from the bottom case. Saved buying a replacement laptop. Disconnect the speaker assembly cable from the motherboard. There was one screw in the battery compartment that would not tighten when I re-assembled the laptop. Unfortunately, there is no easy access to the fan. Was it making loud grinding noise before the cleaning? So I had to hard boot the laptop again, and it has not even shown me a display of any kind since then.
Can someone help me on this? The error code lights next to the caps lock and above the number pad just blink once every 2 seconds but they never stop. From what I gather, it is a power issue that occurs mostly due to some problem with the system coming out of sleep mode. The hinge cover is available using spare part number 537844-001. Is there a way to replace it without disassembling top side of the laptop? As you see, the cooling fan is dusty and has to be cleaned. Is there something I can do? The power jack harness and motherboard are two different parts. I had 2 problems, one was overheating and switching off, ambient room temp around 40 degrees celcius. There was no grinding at all prior to the cleaning, it seemed to be working fine despite the loud noise during intense use.
Chapter 4 Removal and replacement procedures. Have you heard of this? Actual accessible capacity is less. Nothing else turns on including the fan, hds or screen. You unlock all three connectors using the same technique as for unlocking the keyboard connector. I asked my daughters what the heck happened and they claimed they have no knowledge of anything happening. Try cleaning the cooling fan.
As a result, at some point when the top was opened the screen got cracked. If anyone has any ideas, please let us know. Un-route both wireless antenna cables and web camera cable from the path on the case. There is no quicker way. I decided to order a new motherboard which I received today and replaced the old one.
Take a look at the device manager. After cleaning it was around temps were 40-60degrees C. Bad connection between the video cable and motherboard. Our goal is to get your laptop back up and running because we have the team and the experience to make it happen for you! Disconnect the following cables from the system board: 1 TouchPad board cable 2 Fingerprint reader board cable Component replacement procedures. Im doing the repair for a friend. Switch direction a few times until all dust is gone.
You must use low density memory why you need to get memory with 8 little black squares on each side of the board, not 4. I did it in 2 hours and it was my first time. Clean up old thermal grease from the heatsink. I had problems with my fan. The only constant is that if I squeeze the display casing at the top of the line s and they go away.
Does it resolve your problem? Cables must be handled with extreme care to avoid damage. It seems like glued to the bottom. I leave my laptop go for a few days and load up a freshly reformatted hd. Have you tried removing memory modules one by one? There should be three plastic latches. Bought a new power supply and same issue. Hopefully that wont be to often.